How to Route SMPP Traffic As a Buyer to One Seller Without Using a Tech Prefix? : Support

How to Route SMPP Traffic As a Buyer to One Seller Without Using a Tech Prefix? Print

Created by: Helpdesk NeuTrafiX

Modified on: Thu, Mar 25, 2021 at 4:32 PM

1. Use unique System Id to configure each Seller bind in your system.

2. If one buyer bind has one seller bind subscribed to (purchased route), there is no need to have a tech prefix in routing. Routing will happen based on System ID as you would do otherwise outside NeuTrafiX too.

3. If one buyer bind has more than one seller bind subscribed to (purchased route), the default route will be in routing if no tech prefix is used. A buyer can set any one seller bind as a default bind for the given buyer bind.

See the picture below:

1. Login to the portal and go to your Account as shown below:

2. After that, go to the column "Action" and click edit button as shown in the picture below:

3. Page will be directed to the Account Editor as shown in the picture below:

*In the table above, you can see the Tech Prefix list.

Helpdesk is the author of this solution article.

Did you find it helpful? Yes No

How to Route SMPP Traffic As a Buyer to One Seller Without Using a Tech Prefix? Print

Related Articles